CFYHY - F42-0412 CLC 700/800 STARTER BLUE(CYAN)

  • MSDS: CFYHY
  • Manufacturer: CANON IND
  • Product Name: F42-0412 CLC 700/800 STARTER BLUE(CYAN)
  • National Stock Number: 6850-01-431-9420
Product Identification

Product ID:F42-0412 CLC 700/800 STARTER BLUE(CYAN)
MSDS Date:02/01/1994
FSC:6850
NIIN:01-431-9420
MSDS Number: CFYHY

Responsible Party
CANON IND
30-2 SHIRMOMARUKO 3 CHOME OMTA-KU
TOKYO
JA

Emergency Phone: 800-424-9300(CHEMTREC)

Info Phone: 516-328-5600

Preparer: JOSEPH PALMERI

Cage: EO160

Contractor
CANON USA INC
ARLINGTON, VA 22204-5799 US

Telephone: 703-807-3191

Cage: 4J871

Ingredients

FERRITE POWDER MIXTURE, INCLUDES INGREDS 2-4

Fraction By Weight: 90-95%


IRON OXIDE

CAS: 1309-37-1

RTECS: NO7400000

Fraction By Weight: SEE #1%

OSHA PEL 10 MG/M3 (FE)

ACGIH TLV: 5MG(FE)/M3FUME,B2;96


ZINC OXIDE (SARA 313) (CERCLA)

CAS: 1314-13-2

RTECS: ZH4810000

Fraction By Weight: SEE #1%

OSHA PEL 15 MG/M3 TDUST

ACGIH TLV: 10 MG/M3 TDUST; 9596


CUPRIC OXIDE

CAS: 1317-38-0

RTECS: GL7900000

Fraction By Weight: SEE #1%

OSHA PEL 1 MG CU/M3

ACGIH TLV: 1 MG CU/M3


POLYESTER RESIN

CAS: 39382-25-7

Fraction By Weight: 3-10%


PIGMENT (BLUE)

Fraction By Weight: <1%

Hazards

LD50 LC50 Mixture:LD50 ORAL,RATS>5000MG/KG,SIMILAR TONER
Routes of Entry: Inhalation:YES Skin:YES Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:INHAL:EXPECTED TO BE LOW HAZ FOR
RECOMMENDED HNDLG.EYE:NO SPECIFIC HAZ KNOWN.MAY CAUSE TRANSIENT
IRRIT.NOT CLASSIFIED AS IRRIT ACCORDING TO OSHA HCS.SKIN:EXPECTED
TO BE LOW HAZ FOR RECOMMENDED HNDLG.N OT CLASSIFIED AS IRRIT
ACCORDING TO OSHA HCS.INGETS:EXPECTED TO BE LWO INGEST HAZ.CHRONIC
TOXICITY:NO DATA AVAILABLE.
Explanation of Carcinogenicity:PER MSDS:CARCINOGENICITY
CLASSIFICATION:IARC/NTP/OSHA:NONE.
Effects of Overexposure:BASED UPON AVAI DATA HUMAN EXPO TO TONER HAS
BEEN SHOWN TO CAUSE MIN RESP TRACT IRRIT AS MAY OCCUR W/LG AMTS OF
ANY NON-TOXIC DUSTS.RESULTS OF 1 ANIMAL STUDY WHERE RATS INHAL
TONER THAT WAS 10X MORE R ESPIRABLE THAN COMMERC AVAI TONER WERE
OBSERVED TO HAVE NO LUNG CHANGES @LOW EXPO(MOST RELEVANT LEVEL TO
HUMANS)(SUPPLE)
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.

First Aid

First Aid:INHAL:IF SYMPTOMATIC MOVE TO FRESH AIR.GET MEDA TTN IF
SYMPTOMS PERSIST.EYE:ANY MATL THAT CONTACT EYE SHOULD BE WASHED OUT
IMMED W/WATER.GET MED ATTN IF SYMPTOMS OCUR.SKIN:WASH
W/SOAP/WATER.GET MED AT TN IF SYMPTOMS OCCUR.INGEST:DRINK 1-2
GLASSES OF WATER.SEEK MED ATTN.

Fire Fighting

Flash Point:NA
Lower Limits:NA
Upper Limits:NA
Extinguishing Media:WATER SPRAY, CARBON DIOXIDE (CO2),DRY CHEMICAL.
Fire Fighting Procedures:NONE
Unusual Fire/Explosion Hazard:POWDERED MATL MAY FORM EXPLISVE DUST-AIR
MIXTURES. NON-FLAMMABLE SOLID (ACCORDING TO TEST METHODS OF
16CFR1500.44).

Accidental Release

Spill Release Procedures:SWEEP MATERIAL ONTO PAPER AND PLACE IN FIBER
CARTON.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling

Handling and Storage Precautions:AVOID BREATHING DUST.USE W/ADEQUATE
VENTI.KEEP FROM CONTACGT W/OXIDIZING MATLS.MINIMIZE DUST
GENERATION/ACCUMULATION.KEEP CNTNR CLOSED.
Other Precautions:REF PAMPHLET #654:"PREVENTION OF FIRE/DUST EXPLO IN
CHEMS,DYE,PHARMACEUT,PLASTICS INDUSTRIES".MATL HASNT BEEN TESTED
FOR ENVIRO EFFEECTS.IN SPILL SITUTAION MATL MAY BE VISUALLY
UNPLEASANT;HOWEVER NOT EXPECTED TO CAUSE ADVERSE ENVIRO EFFECTS

Exposure Controls

Respiratory Protection:NONE SHOULD BE NEEDED.
Ventilation:GOOD VENTI(TYPICALLY 4-6 ROOM VOL/HR)SHOLD BE
USED.VENTILATION RATES SHOULD BE MATCHED TO CONDITIONS.
Protective Gloves:IMPERV GLOVES FOR PROL/REP SKIN CONTACT
Eye Protection:GOOD INDUSTR HYG PRAC TO MIN EYE CONTACT
Other Protective Equipment:WASHING FACILITIES.
Work Hygienic Practices:WASH WELL AFT HNDLG.GOOD INDUST HYGIENE PRAC
SHOULD BE FOLLOWED WHICH INCLUDES PREVENT EYE CONTACT,MIN SKIN
CONTACT/INH.
Supplemental Safety and Health
OVEREXPO:@HIGHER LEVELS SLIGHT DEGREEE OF LUNG FIBROSIS WAS OBSERVED
DUE TO EXCESSIVE AMTS OF DUST RETAINED IN LUNGS FOR PROL INTERVAL.
RCRA:DISCARDED IN PURCHASED FORM PROD WOULDNT BE HAZ WASTE.HOWEV ER
END USER RESPONSIBILITY TO DETERMINE@DISPO TIME WHETHER MATL
CONTAINING PROD/DERIVED FRM PROD SHOULD BE HAZ WASTE.

Chemical Properties

HCC:N1
Boiling Pt:B.P. Text:NP
Melt/Freeze Pt:M.P/F.P Text:NA
Decomp Temp:Decomp Text:NP
Vapor Pres:NA
Vapor Density:NA
Spec Gravity:4.0-4.5
pH:NA
Evaporation Rate & Reference:NA
Solubility in Water:NEGLIGIBLE
Appearance and Odor:SOLID POWDER, BLUE (CYAN) COLOR, SLIGHT PLASTIC
ODOR
Percent Volatiles by Volume:NA
Corrosion Rate:NP

Stability

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS.
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:CARBON DIOXIDE, CARBON
MONOXIDE.COMBUSTION WILL PRODUCE CO2,POSSIBLY TOXIC CHEMS SUCH AS
CO OR OXIDES OF NITROGEN.

Disposal

Waste Disposal Methods:INCINERATE/LANDFILL.CAN BE INCINERATED WHEN IN
COMPLIANCE W/LOC REGS.DISCH/TREAT/DISPO MAY BE SUBJ TO
NAT/STATE/LOC LAWS.EMPTY RECEPTACLE MAY BE RECYLCLE.CHEM SUBJ TO
SEC 313 TITLE III SARA/40CFR372:C OPPER/CMPDS 15%,AS CU
12%,ZINC/CMPDS 15%,AS ZN 12%

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.